Investigation of the Properties of High-Strengh Aluminum Alloy 1580 for Producing Deformed Semi-Finished Products Suitable for Use Under the Far North and Arctic Conditions

Тип публикации: статья из журнала

Год издания: 2022

Идентификатор DOI: 10.1007/s11015-022-01244-y

Ключевые слова: aluminum, aluminum alloys, casting, low-temperature testing, mechanical properties, percent elongation, scandium, sheet ingots, ultimate tensile strength, yield strength

Аннотация: The paper presents the comparative results of mechanical tensile testing at room (20 ± 10°C) and reduced (–196 ± 5°C) temperature of the cold- and hot-rolled samples of a semi-finished sheet product made of alloy 1580. The test samples were obtained from the 12 mm thick hot-rolled as well as 2 and 4.5 mm thick cold-rolled semi-finished products. The tests were performed in compliance with GOST 1497-84 and GOST 22706-77. According to the test results, the strength and plastic characteristics of the semi-finished sheet product made of alloy 1580 are higher at the lower temperature compared to those measured at the room temperature. Specifically, the ultimate tensile strength of the samples is higher by 20%, yield point — by 11%, and percent elongation — by 40%. © 2022, Springer Science+Business Media, LLC, part of Springer Nature.

Ссылки на полный текст

Издание

Журнал: Metallurgist

Выпуск журнала: Vol. 65, Is. 9-10

Номера страниц: 1036-1042

ISSN журнала: 00260894

Издатель: Springer

Персоны

Stepanenko N.A. (Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”, Krasnoyarsk, Russian Federation)
Yur’ev P.O. (Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”, Krasnoyarsk, Russian Federation)
Bezrukikh A.I. (Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”, Krasnoyarsk, Russian Federation)
Belyaev S.V. (Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”, Krasnoyarsk, Russian Federation)
Partyko Y.G. (Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”, Krasnoyarsk, Russian Federation)
Yanov V.V. (Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”, Krasnoyarsk, Russian Federation)

Вхождение в базы данных

Информация о публикациях загружается с сайта службы поддержки публикационной активности СФУ. Сообщите, если заметили неточности.