Сибирский федеральный университет

Тип публикации: доклад, тезисы доклада, статья из сборника материалов конференций

Конференция: International Scientific Conference on Construction and Architecture: Theory and Practice for the Innovation Development 2019, CATPID 2019

Год издания: 2019

Идентификатор DOI: 10.1088/1757-899X/698/7/077002

Аннотация: A new technical solution of the road printer proposed to improve the efficiency of the device and reduce the complexity in the application of complex graphic images on asphalt concrete pavement to improve road safety was considered. The results of theoretical studies of the "Road Printer" project with the implementation of a simulation model of the automatic control system for a stepper motor of a road printer using the MATLAB & Simulink software are presented. The results of modeling a control system model with synthesized parameters of the proportional-integral-differentiating (PID) controller are given. © 2019 Published under licence by IOP Publishing Ltd.

Журнал: IOP Conference Series: Materials Science and Engineering

Выпуск журнала: Vol. 698, Is. 7

Номера страниц: 77002

ISSN журнала: 17578981

Издатель: Institute of Physics Publishing

• Yemelyanov R.T. (Siberian Federal University, 82, Block. 23 (K), Svobodny Ave., Krasnoyarsk, 660041, Russian Federation)
• Klimov A.S. (Siberian Federal University, 82, Block. 23 (K), Svobodny Ave., Krasnoyarsk, 660041, Russian Federation)
• Turysheva E.S. (Siberian Federal University, 82, Block. 23 (K), Svobodny Ave., Krasnoyarsk, 660041, Russian Federation)
• Servatinsky V.V. (Siberian Federal University, 82, Block. 23 (K), Svobodny Ave., Krasnoyarsk, 660041, Russian Federation)

• Scopus
• Ядро РИНЦ (eLIBRARY.RU)