Тип публикации: статья из журнала
Год издания: 2021
Идентификатор DOI: 10.1016/j.matlet.2021.130199
Ключевые слова: al alloys, eutectic, microstructure, nanocomposites, phase diagrams
Аннотация: The experimental heat resistant alloy Al-3.3Cu-2.5Mn-0.5Zr (wt. %) has been manufactured using the method of electromagnetic casting (EMC) providing solidification at an ultra-high rate (~104 °C/s). The microstructure, phase composition, mechanical and electrical properties of the alloy in as-cast state and after cold rolling followed by annealing has been extensively studied using both thermodynamic calculations and experimental analysis. The microstructure of the as-cast EMC rod consists of the fine Al2Cu phase inclusions and aluminum matrix where all Mn and Zr and most of Cu are dissolved. The annealing of cold rolled strip at 400 °C allows reaching the optimal combination of strength, electrical conductivity and thermal stability. © 2021 Elsevier B.V.
Издание
Журнал: Materials Letters
Выпуск журнала: Vol. 300
Номера страниц: 130199
ISSN журнала: 0167577X
Издатель: Elsevier B.V.
Персоны
- Belov N.A. (Natl Univ Sci & Technol MISiS, 4 Leninsky Pr, Moscow 119049, Russia)
- Akopyan T.K. (Natl Univ Sci & Technol MISiS, 4 Leninsky Pr, Moscow 119049, Russia)
- Korotkova N.O. (Natl Univ Sci & Technol MISiS, 4 Leninsky Pr, Moscow 119049, Russia)
- Timofeev V.N. (Siberian Fed Univ, 79 Svobodnyy Prospekt, Krasnoyarsk 660041, Russia)
- Shurkin P.K. (Natl Univ Sci & Technol MISiS, 4 Leninsky Pr, Moscow 119049, Russia)
Вхождение в базы данных
Информация о публикациях загружается с сайта службы поддержки публикационной активности СФУ. Сообщите, если заметили неточности.