Тип публикации: статья из журнала
Год издания: 2021
Идентификатор DOI: 10.1007/s00170-021-06665-8
Ключевые слова: aluminum alloys, mechanical properties, microstructure, Sparing doping with scandium, Tig
Аннотация: Aluminum alloys doped with scandium represent a new generation of high-performance alloys that have numerous advantages compared to high-strength aluminum alloys. However, the cost of such alloys is quite high. Thus, scientists have been searching for new alloys sparingly doped with Sc that are suitable for industrial use. The current research aims to study the mechanical properties and microstructure of a multi-pass butt-welded joint of plates made of 1580 alloy of the Al-Mg-Zr system sparingly doped with Sc 0.1 wt%, depending on the shape of a weld groove and the chemical composition of the filler wire. Welding of plates with a thickness of 34.5 mm with X-groove and K-groove was performed by the TIG method in manual mode with filler wires from aluminum alloys. Good weldability and hot crack resistance of 1580 alloy providing ultimate strength of welded joints at the level of 0.84–0.93 of the ultimate strength of the base metal were established. The peculiarity of the thermal cycles of multi-pass welding affects the structure formation. The formed coarse-crystalline structure of the weld from 1580 filler wire leads to reduced mechanical properties of the welded joints, compared to the welded joints obtained with the use of 1561 filler wire. The analysis of the macro- and microstructure of the welded joints is given. The results of SEM and EDS studies of welds are presented.
Издание
Журнал: The International Journal of Advanced Manufacturing Technology
ISSN журнала: 02683768
Издатель: Springer-Verlag London Ltd
Персоны
- Dovzhenko N.N. (Department of Mechanical Engineering,Polytechnic School,Siberian Federal University)
- Demchenko A.I. (Department of Mechanical Engineering,Polytechnic School,Siberian Federal University)
- Bezrukikh A.A. (Department of Mechanical Engineering,Polytechnic School,Siberian Federal University)
- Dementeva I.S. (Department of Mechanical Engineering,Polytechnic School,Siberian Federal University)
- Gaevskiy V.N. (Department of Mechanical Engineering,Polytechnic School,Siberian Federal University)
- Dovzhenko I.N. (Department of Metal forming,School of Non-Ferrous Metals and Material Science,Siberian Federal University)
- Voroshilov D.S. (Department of Metal forming,School of Non-Ferrous Metals and Material Science,Siberian Federal University)
- Baranov V.N. (Department of Joint Metallurgy,School of Non-Ferrous Metals and Material Science,Siberian Federal University)
- Orelkina T.A. (Department of Metal Science and Heat Treatment of Metals named after V.S. Biront,School of Non-Ferrous Metals and Material Science,Siberian Federal University)
- Lopatina E.S. (Department of Metal Science and Heat Treatment of Metals named after V.S. Biront,School of Non-Ferrous Metals and Material Science,Siberian Federal University)
Вхождение в базы данных
Информация о публикациях загружается с сайта службы поддержки публикационной активности СФУ. Сообщите, если заметили неточности.