Сибирский федеральный университет

Тип публикации: статья из журнала

Год издания: 2019

Ключевые слова: Deformation modes, drawing, mechanical properties, nickel, palladium, precious metal alloys, safety factor, stresses, temperature

Аннотация: This article represents the results of studies of the drawing thin wire from the alloy Pd-5Ni process. The studies used the software developed by the authors using the methods of calculating the drawing process and the computer model implemented in the DEFORM 3D software package. By way of calculation, a drawing route was determined, including 14 transitions, and the efforts of deforming the metal were found when producing wire with a diameter of 0.075. For this mode of deformation processing using the DEFORM 3D software package, we simulated the drawing process and established the temperature and stress distribution over the volume of the workpiece. The simulation results confirmed that the calculated safety factor for drawing is in the range of 2.85-3.43, which ensures a stable process of deformation of the metal without breaks and, as a consequence, an increase in productivity and yield of the suitable metal. Experimental studies have confirmed the adequacy of the developed model, so it can be used to analyze the process of drawing wire from other precious metal alloys. The results of the research are recommended to improve the production technology of thin wire from the alloy Pd-5Ni for the manufacture of catalytic gripping grids.

Журнал: Key Engineering Materials

Выпуск журнала: Т.805 KEM

Номера страниц: 13-18

ISSN журнала: 10139826

Издатель: Trans Tech Publications Ltd.

• Sidelnikov S. (Siberian Federal University)
• Bindareva K. (Siberian Federal University)
• Lopatina E. (Siberian Federal University)
• Leonov V. (Siberian Federal University)
• Voroshilov D. (Siberian Federal University)
• Lebedeva O. (Siberian Federal University)
• Rudnitskiy E. (Siberian Federal University)
• Lopatin V. (Siberian Federal University)

• Ядро РИНЦ (eLIBRARY.RU)