Influence of cutting modes on power characteristics of rotational turning by multifaceted cutters : доклад, тезисы доклада

Тип публикации: доклад, тезисы доклада, статья из сборника материалов конференций

Конференция: International Workshop on Advanced Technologies in Material Science, Mechanical and Automation Engineering - MIP: Engineering-2019; Krasnoyarsk; Krasnoyarsk

Год издания: 2019

Аннотация: New data on the effect of technological modes (depth cutting, a m f, longitudinal feed, fn ; azimuthal feed, faz ; cutting speed, Vr ) and constructive factors (geometric and kinematic parameters of the tool) on cutting forces have been obtained. On this basis, semiempirical computational formulas Pz = f (amf, fn, faz, Vr ) for the assignment of rational modes of processing by the method of rotational turning multifaceted cutter (RTMC) are proposed. The obtained numerical values of the cutting forces for PTMC (up to 900N) are much lower than for conventional turning (up to 4000N) at similar values of amf and fn.

Ссылки на полный текст

Издание

Журнал: IOP Conference Series: Materials Science and Engineering

Выпуск журнала: 537

Номера страниц: 032101

Издатель: Institute of Physics Publishing

Персоны

Binchurov A.S. (Aerokosmichesky College of Reshetnev,Siberian State University of Science and Technology)
Indakov N.S. (Siberian Federal University)
Gordeev Y.I. (Siberian Federal University)
Yasinski V.B. (Siberian Federal University)

Вхождение в базы данных

Ядро РИНЦ (eLIBRARY.RU)

Информация о публикациях загружается с сайта службы поддержки публикационной активности СФУ. Сообщите, если заметили неточности.